|
 |
|
|
| Description |
|
Power Cord for:
- 12 volt DC powered LED Rope Lights
- 24 volt DC powered LED Rope Lights(previously part number was IMT-ILMDL-CONKIT-6x12v/24v)
Insert the LED rope light into the compression fitting. This inserts the power cord pins into the LED rope lights to make electrical contact with the wires embedded in the LED rope light. Tighten the compression fitting by hand. Then strip the other end of the cord and hard wire to your power source. |
|
|
Power Cord for hard wiring SPECIFIC LED Rope Lights as listed above
|
| |
|
|
|
|
Key parameters |
Size:
6 foot long power cord for hard-wiring 3/8" Imtra Marine LED rope lights |
Specifications:
Power Cord for:
12 volt DC powered LED Rope Lighting
24 volt DC powered LED Rope Lighting |
Additional Details:
Insert the LED rope lighting into the compression fitting and hand tighten.
Strip the other end of the cord and hard wire it |
| Additional information |
| Installation Note: Before you install your LED rope lights, connect the power and verify illumination. Then as you do your installation, beware of which end you need to feed the power to. Why? LED rope lighting contains diodes that allow the electricity to flow in one direction only. Because of this, when you hook up power to the LED rope lighting, it may not illuminate. If this is the case, disconnect the power and reconnect it to the other end of the LED rope lighting. |
|
| Price |
|
| Customer Reviews |
Average Rating  |
|
| |
Easy to install - made the installation easy and fast. |
| |
Reviewed by: Garry Leiker from bainbridge Island.
on 9/26/2012 |
|
 |
|
|
|
| |
|
|
|
|
Shopping Cart - 0 item(s)
