LED Flex Strips / LED Tape Strips
(LED Strip Light / Flexible LED Strips / Adhesive backed LED Tape Lights)
12 volt LED or 24 volt LED - save energy - SailorSams.com

12VDC or 24 VDC Flexible LED Strip Tape is a linear strip of low power LEDs encased in a flexible, clear epoxy resin. Order below

The thin width (0.31" / 8mm) and extremely low profile (0.08" / 2mm) form factor allow it to be installed in areas too confined for traditional rope light products.

Wide angle SMD LEDs placed every 2/3" result in homogenous and even light distribution without shadows or gaps.

For mounting ease, each section is supplied with 3M double sided tape already installed on the product.

Each section comes with 5" long, 18 AWG wire leads so your LED Strip Tape is ready to connect to your DC power source.

Flexible LED Strip Tape may be cut every 2" (12V version) or every 4" (24V version). Refer to Installation Instructions (pdf file) step 4.

Applications include cove lighting, under cabinet lighting, glass cabinets, wine racks, closets, etc.

Note: This product performs optimally with constant voltage at or near the specified voltage input. It is sensitive to over-voltage and transient spikes, therefore long term performance is dependent on the input voltage provided. For installation on boats, a power conditioner is recommended for maximum life of the product: Power Conditioners

Cool White, color temperature 5500K

Warm white, color temperature 2900K

Blue

Features and Benefits:

• Flat profile

• Flexible clear epoxy cover

• Wide angle SMD LEDs

• Very low power consumption

• Water resistant (IP65)

• 3M double-sided tape (easy installation)

Downloads:

Product Sheet from manufacturer for full details (pdf file).

Installation Instructions from manufacturer (pdf file). **Installation Note**
For mounting ease, each section is supplied with 3M double sided tape already installed on the product. For additional security, the tape can be mechanically secured using Flexible Mounting Straps.

Wiring: The grey wire is soldered to the negative side and the white wire is soldered to the positive side. Double check by looking for the “+” and “-“ printed on the circuit board.

Product Details:

LED Type: SMD
Viewing Angle: 120°
Power Consumption: 1.25 watts/foot (4.1 watts/m)
Luminous Flux:
- Warm White 30 lumens/ft (98 lms/m)
- Cool White 32 lumens/ft (104 lms/m)
- Blue 7 lumens/ft (24 lms/m)
Bulb Spacing: 2/3" (16.5mm)
Cut-ability: 2" (50mm)
Maximum Run: 16.4' (5m) for 12 volt products, 32.8' for 24 volt products
Ingress Protection: IP65
Dimensions: Width < 1/3"  (0.31" / 8mm); Height < 1/10th of an inch (0.08" / 2mm)
Weight: 0.063 lbs / foot

**Special Note for Households or Yachts with Line Voltage**

This low voltage (12VDC or 24VDC) Flexible LED Strip Tape is designed for hard-wire DC hook-up (i.e., from DC power supply or battery source).

If stepping down voltage from a 120/230V source, a standard low voltage AC transformer will damage the product.

You must use a DC power supply or a voltage-regulated LED converter for this purpose.