|
The IML PowerLED Dimmer Module is a low current PWM
(Pulse Width Modulation) electronic dimmer designed to
work with the IML PowerLED spotlights (it cannot be used with
the Newport PowerLED Bi-Color spots).
Order below
This dimmer will drive up
to 15 fixtures and supports an unlimited number of
momentary controls. The low profile, light-weight
design simplifies installation.
Step-less (linear) dimming ranges from 10% to 100% output
(hold the momentary pushbutton until the light
achieves the desired level, and release). Full "on" or
full "off" is accomplished by a single
tap to the momentary control, which will cause the
dimmer to ramp up (or down) over a 4 to 5 second
period. A unique memory feature
remembers the last light level setting automatically.
Designed to meet UL1149. Will operate with 12 or 24
volts DC or 60Hz
low-voltage AC from inductive compatible transformer
such as Imtra's Tector Toroidal Transformers. Also
compatible with Imtra's Voltage-Regulated
LED Converters. Most electronic AC transformers are
not compatible. |
Product Details:
Voltage Input: 12/24VDC or 24VAC
Power Input: 0.6W max
Capacity: 15 PowerLED fixtures
No. of Controls: Unlimited (wired in parallel)
Control Type: Momentary, single pole/single throw.
* Compatible with the following
specific IML Spotlights:
Hatteras Power LED Spotlights
Portland Power LED Recessed Spotlights
Newport Power LED Spotlights
Norfolk Power LED Recessed Spotlights Momentary
Switches and Boxes |
|
IML PowerLED Dimmer Module
Wiring Diagram:
PowerLED Wiring:
Red, Wire
Black Wire:
Power Inputs (Either wire may accept positive or negative
polarity). White Wire:
Dimming Input Signal, Gray Wire:
Dimming Return. Connect the Dim-Return (gray wire) of the
dimmer to the Dim-Return (gray wire) of the IML PowerLED.
PowerLED Installation Instructions (pdf)
|
